Installation, Installing the drive in the carrier preparation – StorCase Technology DE100i-SWCU2 User Manual
Page 14
Installation
7
DE100i-SWCU2 User's Guide - Rev. B02
StorCase Technology, Inc.
INSTALLATION
Installing the Drive in the Carrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation provided with the
drive.
NOTE:
A #2 Phillips screwdriver will be required during this procedure.
1.
Remove the drive from its protective packaging.
2.
Plastic Drive Bezel: If the drive came equipped with a plastic front bezel, it
must be removed.
3.
SCSI Drive Termination: The DE100i-SWCU2 does not provide onboard
termination. External termination must be provided. Refer to the documentation
provided by the drive manufacturer for termination information.
Installation
1.
Carefully insert the drive (Figure 6) into the carrier so that the I/O connector is
flush with the rear of the carrier.
2.
Fasten the drive into place with four (4) #6-32 Phillips Pan Hd. screws (Figure
6).