StorCase Technology DE100i-A100 - Manual (Page 12)

DE100i-A100 User's Guide - Rev. C02 StorCase Technology, Inc.
Introduction 5
Receiving Frame Rear Panel
(Figure 5)
• DC Power Connector (J3): The DE100i-A100 uses a standard 4-pin DC Power
Connector to accept DC power.
• I/O Connector (J2): The input/output connector provides a standard interface for
all IDE signals. See Table 3 on page 13 for J2 pin assignments.
• Master/Slave Selection Jumper (J5): Master Drive configuration (default).
Forces master drive configuration on receiving frame. Change jumper to set slave
drive configuration. Refer to Table 1 on page 12 for further information.
• Device Spin Down/Up Timer Jumper (J6): Jumper installed (Factory Default)
enables device spin down/up visual indicator. Receiving frame unit ID number
display (Figure 4) will flash to indicate device spin down/up.
Figure 4: Receiving Frame Unit ID Number and Activity Display