Star Headlight & Lantern 5600 Series 66" Warning Packages - Manual (Page 17)

-14-
(LED Pattern Programming CONT’D)
Patterns for All LEDs Excluding DLX6 and Batwing
(LDF398 Flasher)
Pattern Warning Pattern Style
1 Pursuit Mode (Default)
2 Alternating Slow Single (1-5 vs 6-10) (Title 13 Approved)
3 Alternate Pursuit Mode
4 Alternating Quad Flash (1-5 vs 6-10)
5 Alternating Triple (1,2,6,7,8 vs 3,4,5,9,10)
6 Alternating Quint (1,2,6,7,8 vs 3,4,5,9,10)
7 Simultaneous Slow Single (All Modules) (Title 13 Approved)
8 Simultaneous Fast Single (All Modules)
9 Simultaneous Triple Flash (All Modules)
10 Simultaneous Quad Flash (All Modules)
11 Simultaneous Quint Flash (All Modules)
12 Simultaneous Fast Triple Flash (All Modules)
13 Simultaneous Fast Quint Flash (All Modules)
14 In/Out Single (1,2,9,10 vs 3-8)
15 In/Out Triple (1,2,9,10 vs 3-8)
16 In/Out Quint (1,2,9,10 vs 3-8)
17 In/Out Single (1,2,3,8,9,10 vs 4-7)
18 In/Out Triple (1,2,3,8,9,10 vs 4-7)
19 In/Out Quint (1,2,3,8,9,10 vs 4-7)
20 1-5 Steady; 6-10 Single Flash (Title 13 Approved)
21 1-5 Steady; 6-10 Slow Single Flash (Title 13 Approved)
22 6-10 Steady; 1-5 Single Flash (Title 13 Approved)
23 6-10 Steady; 1-5 Slow Single Flash (Title 13 Approved)
24 Sequential Back And Forth
25 Sequential In/Out
26 Burst All w/ Alternating Burst
27 Alternating Burst w/ Simultaneous Double Then Quint
28 Simultaneous Burst w/ Alternating Double Then Quint
29 Hyper-Random
30 Demo (Cycle Through Patterns 1-4,6-9,13-20,25-29)
Each LED flasher has 20 output terminals (10 pairs). The two terminals in each pair are
electrically connected and will flash at the same time. The numbers in the list above, in
the parenthesis, indicate which output pairs flash together vs. the pairs they flash
opposite of.
Please Note: At any time during the programming sequence, you can reset the flash
pattern back to the default mode (Pattern 1 – Pursuit) by holding the red
w/green Pattern Select wire to +12VDC for 5 seconds, then releasing it.
Black = Ground
Red/Green = Pattern Select
Large Red = Power
White = Corner Enable
Orange = Outboard Enable
Brown = Inboard & Ends
Purple = High/Low Power
L
a
rg
e
R
e
d
Red/Green
Black
Purple
Brown
Orange
White
Please Note: The 20
output terminals are
enabled by 3 different
inputs:
White - 1,2,9,10 (Corners)
Orange - 3,8 (Outboard)
Brown - 4,5,6,7 (Inboard
& Ends)
Output Pair
1
2
3
4
5
6
7
8
9
10
Flasher Unit for All LEDs Excluding DLX6 and Batwing
(LDF398 / 8070-285-1)