Star Headlight & Lantern 5600 Series 66" Warning Packages - Manual (Page 15)

-12-
Front and Rear DLX6 and Batwing LED Patterns
(LDF375-1 Flasher)
Pattern Warning Pattern Style
1 Pursuit Mode (1 flash/3 sec default)
2 Alternating Slow Single (1-5 vs 6-10) (Title 13 Approved)
3 Alternate Pursuit Mode
4 Alternating Quad Flash (1-5 vs 6-10)
5 Alternating Triple (1,2,6,7,8 vs 3,4,5,9,10)
6 Alternating Quint (1,2,6,7,8 vs 3,4,5,9,10)
7 Simultaneous Slow Single (All Modules) (Title 13 Approved)
8 Simultaneous Fast Single (All Modules)
9 Simultaneous Triple Flash (All Modules)
10 Simultaneous Quad Flash (All Modules)
11 Simultaneous Quint Flash (All Modules)
12 Simultaneous Fast Triple Flash (All Modules)
13 Simultaneous Fast Quint Flash (All Modules)
14 In/Out Single (1,2,9,10 vs 3-8)
15 In/Out Triple (1,2,9,10 vs 3-8)
16 In/Out Quint (1,2,9,10 vs 3-8)
17 In/Out Single (1,2,3,8,9,10 vs 4-7)
18 In/Out Triple (1,2,3,8,9,10 vs 4-7) (2 flashes/6 sec default)
19 In/Out Quint (1,2,3,8,9,10 vs 4-7)
20 1-5 Steady; 6-10 Single Flash (Title 13 Approved)
21 1-5 Steady; 6-10 Slow Single Flash (Title 13 Approved)
22 6-10 Steady; 1-5 Single Flash (Title 13 Approved)
23 6-10 Steady; 1-5 Slow Single Flash (Title 13 Approved)
24 Sequential Back And Forth (3 flashes/9 sec default)
25 Sequential In/Out
26 Burst All w/ Alternating Burst
27 Alternating Burst w/ Simultaneous Double Then Quint
28 Simultaneous Burst w/ Alternating Double Then Quint
29 Hyper-Random
30 Pre-Pop Triple Flash
31 Alternating Pre-Pop Triple Flash
32 Demo (Cycle Through Patterns 1-4,6-9,13-20,25-29)
Please Note: At any time during the programming sequence, you can reset the flash
pattern back to any of the default patterns (Pattern 1, 18, or 24) by holding
the red w/green Pattern Select wire to +12VDC until the heads flash the
specified number of times, then releasing it.
Each LED flasher has 20 output terminals (10 pairs). The two terminals in each pair are
electrically connected and will flash at the same time. The numbers in parenthesis in the
list above indicate which output pairs flash together vs. the pairs they flash opposite of.
LED Flash Patterns
1
2
3
4
5
6
7
8
9
10
Output Pair
Please Note: The 20 output
terminals are enabled by 3
different inputs:
White - 1,2,9,10 (Corners)
Orange - 3,8 (Outboard)
Brown - 4,5,6,7 (Inboard & Ends)
White
Orange
Brown
Yellow
Red/Green
Black
Purple
L
a
rg
e
R
e
d White = Corner Enable
Orange = Outboard Enable
Brown = Inboard & Ends
Yellow = Cruise
Red/Green = Pattern Select
Black = Ground
Purple = High/Low Power
Large Red = Power
Front and Rear DLX6 and Batwing LED Flasher Units
(LDF375-1 / 8070-375-1)