Star Headlight & Lantern 5600 Series 66" Warning Packages - Manual (Page 11)

-8-
(Strobe Pack Connections For Lightbars With 4 Linear Heads CONT’D)
Activating the Front and Rear Strobes Separately
If you would like the ability to switch the Front Strobes On and Off separate from the Rear
Strobes, connect the White w/Green Stripe wire to the switch that will activate your Front
Strobes, and connect the Black w/Green Stripe wire to the switch that will activate your
Rear Strobes.
The Red wire must be connected to constant +12VDC.
Please Note: When the red wire is connected to +12VDC the pack will draw a small
current (50 mA). If your vehicle will be sitting for extended periods of time
(i.e. more than a few days), it is recommended this wire be routed through
a switch or a high-current ignition switched relay.
Front Strobes
On/Off Switch
CONNECT
TO +12 VDC
Black w/Green
H
a
rn
e
s
s
fr
o
m
L
ig
h
tb
a
r
White w/Green
CONNECT
TO +12 VDC
Rear Strobes
On/Off Switch
Touch and Release To
+12VDC to Change Pattern
DO NOT PERMANANENTLY CONNECT
Red w/Green Stripe TO +12VDC!!!
CONNECT TO CONSTANT +12 VDC
Please Note: When the Red wire is connected to +12VDC the pack will
draw a small current (50 mA). If your vehicle will be sitting for extended
periods of time (i.e. more than a few days), it is recommended the Red wire
be routed through a switch or a high-current ignition switched relay.
!
Red w/Green
Red
Proceed to the Pattern Programming section on page 11 to program the flash pattern of your
strobe pack.
Note: If you have power to both White w/Green and Black w/Green #1 & #4 will flash together
alternating with #2 & #3. For two outlet packs, the two heads will alternate.