Spectrum Controls 1762sc-IF4OF4 - Manual (Page 24)

3-2 MicroLogix™ 1200 Analog Combo Module (4Ch IN / 4Ch Out)
User’s Manual Pub. 0300247-01 Rev. C
Section 3.3
Add Module
to Logix 500
The following procedure describes how to add the IF4OF4 module to the RSLogix 500
programming software.
1.) Create a new RSLogix 500 project and select either a Micro 1100, 1200, or 1400
processor.
2.) Double-click “I/O Configuration” from the project tree.
3.) Select the first empty slot and then double-click the “Other—Requires I/O Card
Type ID” option, from the I/O configuration screen.
4.) Enter the module profile data as shown in the figure below and click “OK”.