Spectrum Controls 1762sc-IF4OF4 - Manual (Page 16)

2-4 MicroLogix™ 1200 Analog Combo Module (4Ch IN / 4Ch Out)
User’s Manual Pub. 0300247-01 Rev. C
Section 2.4
Mounting
!
Attention
Do not remove protective debris strip until after the module and all
other equipment near the module is mounted and wiring is complete.
Once wiring is complete and the module is free of debris, carefully
remove protective debris strip. Failure to remove strip before operating
can cause overheating.
2.4.1 Minimum Spacing
Maintain spacing from enclosure walls, wireways, adjacent equipment, etc. Allow 50.8
mm (2 in.) of space on all sides for adequate ventilation, as shown:
Figure 2-1
Note: 1762 expansion I/O may be mounted horizontally only.
!
Attention
During panel or DIN rail mounting of all devices, be sure that all debris
(metal chips, wire strands, etc.) is kept from falling into the module.
Debris that falls into the module could cause damage when power is
applied to the module.
2.4.2 DIN Rail Mounting
The module can be mounted using the following DIN rails: 35 x 7.5 mm (EN 50 022 - 35
x 7.5) or 35 x 15 mm (EN 50 022 - 35 x 15).
Before mounting the module on a DIN rail, close the DIN rail latch. Press the DIN rail
mounting area of the module against the DIN rail. The latch will momentarily open and
lock into place.
Use DIN rail end anchors (Allen-Bradley part number 1492-EA35 or 1492-EAH35) for
environments with vibration or shock concerns.