Sioux Tools SCN CLINCH NUT TOOLS - Manual (Page 3)

Form ZCE782 3 Date 2013February5/D
SOUND AND VIBRATION READINGS
Catalog No.
*Sound Pressure
dBA
*Sound Power
dBA
*Vibration m/s 2
SCN3R 80.0 91.6 Less than 2.5
SCN5R 80.0 91.6 Less than 2.5
SCN7R 80.0 91.6 Less than 2.5
SCN12R 80.0 91.6 Less than 2.5
SCN20R 80.0 91.6 Less than 2.5
SCN25R 80.0 91.6 Less than 2.5
SCN10S12 80.0 91.6 Less than 2.5
*per PN8NTC1 *per PN8NTC1 *per ISO 8662
DECLARATION OF CONFORMITY
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
SCN SERIES
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
EN 792, ISO 12100-1, ISO 12100-2, ISO 8662, Pneurop PN8NTC1
following the provisions of
98/37/EC.
May 1, 2009
Murphy, North Carolina, USA
Date and place of issues
Robert Hartman
Vice President and General Manager-Power Tools
Sioux Tools Inc
Name and position of issuer
Signature of issuer
Changing Heads.
1. Add a nut or short screw to the head assembly to retain the internal parts.
2. Loosen and remove the ring SDR-91.
3. Remove the head assembly and the hex drive bit.
4. Install the new head assembly making sure the hex bit is seated in the drive spindle and the fastener head. Remember that all stud-type tools use
the same bit, but each nut-type head uses a bit matched to the arbor size.
5. Replace and tighten the ring.
6. Remove the retaining nut or screw before operating the tool.