Sioux Tools 1456ES - Manual

1
*Sound Pressure *Sound Power *Vibration
Catalog No. dBA dBA m/s 2
1449ES 78.0 90.0 Less than 2.5
1450ES 78.0 90.0 Less than 2.5
1451ES 78.0 90.0 Less than 2.5
1452ES 78.0 90.0 Less than 2.5
1454ES 78.0 90.0 Less than 2.5
1455ES 78.0 90.0 Less than 2.5
1456ES 78.0 90.0 Less than 2.5
*per PN8NTC1 *per PN8NTC1 *per ISO 8662
INSTRUCTIONS AND PARTS LIST FOR 1449ES, 1450ES, 1451ES, 1452ES, 1454ES,
1455ES, 1456ES DRILLS
(SERIAL “C”)
Read and understand "Safety Instructions For Air Tools" and these instructions before
operating this tool.
AIR SUPPLY
The efficiency of the tool is dependent on the proper supply of clean dry air at 90 psig (6.2 bar). The use of a line filter,
pressure regulator, and lubricator will insure maximum output and life of tools. Before connecting tool, blow out the air line to
remove water and dirt which may have accumulated.
HOSE AND HOSE CONNECTIONS
Supply hose should be not less than 3/8" (10mm) I.D. Extension hoses should be at least 1/2" (13mm) I.D. Use couplings and
fittings with at least 3/8" (10mm) I.D.
LUBRICATION
Use SIOUX No. 288 air motor oil. An airline lubricator, set to deliver 2 to 4 drops per minute, is recommended. If a lubricator is
not used, add .04 oz. (1.2cc, 12 to 15 drops) of oil into the air inlet twice daily.
Lubricate the gearing every 100 hours of operation with SIOUX No. 289A grease.
GENERAL OPERATION
This tool is equipped with a teasing throttle. By slightly depressing the trigger the chuck will rotate slowly. This is useful for
starting a drill bit without first spotting with a punch. The tool will run at maximum speed when the trigger is fully depressed.
If the gear case is removed or loosened, re-tighten to 35 ft-Ib.
SOUND AND VIBRATION READINGS
Form ZCE476C
Date 2004January6/A
Page 1 of 10
Printed In U.S.A.
DECLARATION OF CONFORMITY
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
1449ES, 1450ES, 1451ES, 1452ES, 1454ES, 1455ES, 1456ES including B, LC, Y suffixes
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
EN 792 (draft), EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
January 1, 2004
Murphy, North Carolina, USA
Date and place of issues
Gerald E. Seebeck
President
Sioux Tools Inc.
Name and position of issuer Signature of issuer