Simaudio Neo 340i Integrated Amplifier - Manual (Page 14)

340i Integrated Amplifier
____________________________________________________________________________________
14
Operating the 340i
We recommend leaving your Nēo 340i powered up
at all times to maintain optimal performance. When
you plan on being away for a few days, it may not
be a bad idea to power off your amplifier. Please
keep in mind that once fully “broken-in”, your 340i
requires several hours of operation before reaching
optimal performance after powering it up again.
Turning on your MOON 340i for the first time
Prior to turning the amplifier on for the first time,
make sure that every cable is properly connected to
avoid any problems. Flick the main rocker switch,
located on the rear panel, labeled “POWER” to the
‘1’ (on) position. The blue LED on the front panel
will blink for up to 10 seconds while it achieves
standby mode. When it stops blinking and is not
illuminated, your 340i is in standby mode. Next,
briefly press the push button labeled “Standby”
located on the front panel. You will hear a very faint
click sound confirming that everything is in order.
The blue LED on the front panel will illuminate,
indicating that the 340i is now powered up and
ready for use.
On and Off Sequence
To avoid having any annoying noises (ie. “thumps”
and “pops”) emanate from your speakers when
powering your 340i on or off, you should always
power up any source components prior to powering
up your 340i. As well, always power down your
340i prior to powering down any source
components.