RTA Products RTA-S07 - Manual (Page 8)

P.8 RTA-S07
14
15
15
14
16
12
Right
Left
12 X3
X3
SCREWS
C
12PCS
3X15 MM
SCREWS
4PCS
6X40 MM A
14
15
17
3
4 5
Screw the Bolts (A) to the corresponding holes on the inside
face of Left & Right Panels (14&15), then assemble the
panels to the Bottom Panel (16) by turning all the
corresponding cam locks.
Grab all the flat shaped sliders (12) and set aside the “L” shaped ones. Assemble the sliders to the inside
face of the Left & Right Panels (14&15) with using Screws (C). The wheels will be located at the front and
facing down.
If you don't see the holes, pass the tip of your finger around the area where
the holes should be, pressing against the surface to feel the indentation.
Slide the Back Panel (17) thru the channels in
between panels (14), (15) & (16) as shown.
Make sure the panel fits inside all the
channels.
16