ROHO AGILIT Fixed Hardware - Manual (Page 4)

- 4 -
AGILITY FIXED HARDWARE INSTALLATION OPTION A
1
Loosen the back cane hardware bolt until the
end of the bolt is flush with the adjustment
cylinder. The adjustment cylinder should be
advanced as far as it can go.
DO NOT completely remove the
back cane hardware bolt from the
adjustment cylinder.
3
(Repeat 1 and 2 for the opposite side.)
2
a) With the back cane hardware bolt held in,
push the back cane band toward the bolt to
unclip the back cane band from the adjust-
ment cylinder.
b) Flip the back cane band fully open.
2a
2b
Make sure mounting hardware
is flush against the back cane.
4
a) Rotate the back cane band around
the back cane.
b) Push against the back cane hard-
ware bolt with thumb.
c) Pinching the back cane band, clip
the opening of the back cane band
around the end of the adjustment
cylinder.
4c
4b
4a
a) Push against the back cane hardware bolt with
thumb.
b) Position the narrow end of the cane band’s
opening into the groove at the end of the adjustment
cylinder.
5
5a
5b
Continued on top of next page
Tighten the back cane hardware bolt on each
side by hand.
6