ROHO SelectProtec safety enhancement system - Manual (Page 10)

9
Section 6 Cleaning and Disinfecting
CLEANING AND DISINFECTING
Note:
Cleaning and disinfecting are two different processes. To be effective, cleaning must
precede disinfecting.
The SelectProtect must be cleaned, disinfected, and checked for proper functioning
between multiple patient use.
Disassemble the SelectProtect before cleaning or disinfecting any of its components
between patients.
To clean the SelectProtect cover while in use:
Wipe surface with pH neutral soap and warm water. Rinse with water and dry.
To clean SelectProtect cover between patients:
Remove cover from mattress and remove foam bolsters from
pockets. Machine wash in warm water. No bleach, Tumble dry low.
DO NOT use high heat.
To disinfect SelectProtect cover between patients:
Machine wash in hot water (sanitizing cycle). No bleach. Tumble
dry low.
Note: Disinfectants are not effective on porous surfaces such as foam. If the foam
bolsters become soiled or contaminated,
DO NOT use. Replacement foam bolsters may be
purchased. Replace the foam bolsters with components supplied by ROHO, Inc. only.
For cleaning and disinfecting the SelectAir mattress replacement, mattress pad, or control
unit during use or between patients, refer to the instructions in the SelectAir Operations
Manual.
•
•
•