Denon AVR-1907 - Manual (Page 59)

ENGLISH
56
ENGLISH
Advanced Setup – Part 2 Advanced Setup – Part 2
• The distance changes in units of 0.5 foot each time the button is
pressed. Select the value closest to the measured distance.
• Please note that the difference of distance for every speaker
should be 20 ft or less.
1
2
..... L1
..... L2
..... L3
..... L4
..... L5
..... L6
..... L7
..... L8
Set the volume of the various speakers so that the sound output from
the speakers and the subwoofer seems to have the same volume
level.
Press D D H H to select “Channel Level”, then press ENTER .
Press D D H H to select “Test Tone Start”, then press F F to
select “Yes”.
Press F F G G to set.
When “Auto” mode is selected:
Press
F F G G to adjust the volume.
• Test tones are output automatically, in the order shown below.
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output switched
manually.
FL
SW
C FR SR
SBL SL
SB
SBR
Setting the Channel Level
The volume can be adjusted within the range –12 dB to +12 dB.
When “Manual” mode is selected:
Press
D D H H to select the speaker, then press F F G G to
adjust the volume.
Press ENTER .
1
2
3
4
-1
4
-2
5
(2 speakers)
(1 speaker)
• To cancel the setting, press H H and select “Level Clear”, then press
F F and select “Yes”.
• To adjust the channel level separately for the different play modes
after setting the channel level, perform the operation on page 32.
1
2
3
4
-1