Denon AVR-1907 - Manual (Page 58)

ENGLISH
55
ENGLISH
Advanced Setup – Part 2 Advanced Setup – Part 2
Press ENTER .
A subwoofer with sufficient low frequency playback capability can
better handle deep bass than most main and surround speakers,
and the system’s overall performance will be greatly enhanced
when “Small” is set for the main (front) and surround speakers.
When “Front” is set to “Small”, “Subwoofer” is automatically set
to “Yes”, and when “Subwoofer” is set to “No”, “Front” is
automatically set to “Large”.
4
• Select “Large” or “Small” not according to the actual size of the speaker
but according to the speaker’s capacity for playing low frequency
(bass sound below the frequency set for the Crossover Frequency)
signals. If you do not know, try comparing the sound at both settings
(setting the volume to a level low enough so as not to damage the
speakers) to determine the proper setting.
1
2
3
Setting the Subwoofer Setup
Select the method of playback of the subwoofer for playing the low
bass signals.
Press D D H H to select “Subwoofer Setup”, then press
ENTER .
Press F F G G to set.
LFE (Normal):
For any channel(s) that are set to “Large”, low frequencies in that
channel’s corresponding source are directed to that loudspeaker
only. The low frequencies played from the subwoofer are only the
LFE signals and the low frequencies of channels set to “Small”.
LFE+Main:
Low frequencies from speaker channels that have been set to
“Large” are reproduced from those speakers as well as from the
subwoofer(s).
• The subwoofer mode setting is only valid when and “Yes” is set for
the subwoofer in the “Setting the Speaker Configuration”.
• Select the “LFE+Main” mode if you want low frequency signals to
always be played from the subwoofer channel.
• Select the mode achieving a voluminous bass sound when playing
music or movie sources.
Press ENTER .
1
2
3
Setting the Distance
This parameter is for optimizing the timing with which the audio
signals are produced from the speakers and subwoofer according to
the listening position.
Preparations:
Measure the distances between the listening position and the
speakers (L1 to L8 on the diagram at the below).
Press D D H H to select “Distance”, then press ENTER .
L1 L2
L3
L8
L4 L5
L6 L7
C FR FL
SW
Listening position
SL SR
SBL SBR
1
1
2
Press D D H H to select the speaker, then press F F G G to set. 2
Press ENTER .
3
Center speaker
Front speaker
Subwoofer
Surround speaker
Surround back speaker