Rocktron Blue Thunder - Manual (Page 58)

Operating the Blue Thunder
Step 5 Press the STORE button at this time to initiate the All Restore procedure and erase all current
Blue Thunder presets, replacing them with the original factory presets. The Blue Thunder will
display "INITIALIZING" as the Blue Thunder memory is restored.
INITIALIZING
After the All Restore process is completed, the display should read "ERRORS 0". This is the
number of bytes that the Blue Thunder found that did not initialize properly. Any number of
errors other than "0" means that the Blue Thunder may not have initialized properly and the
process should be repeated.
ERRORS 0
The Blue Thunder will remain in this condition until the FUNCTION SELECT
control is turned to exit the Factory Restore function. The preset currently recalled
will be the preset most recently restored into the current location.
The controller assignments for the Blue Thunder can also be reinitialized with-
out affecting presets and other stored information.
To reinitialize only the controller assignments, enter a code number of "244" at
Step 3 on the preceding page (instead of the "243" shown).
Restoring the Blue Thunder controller assignments:
55