Record – Rocktron Blue Thunder User Manual

Page 51

To dump a single Blue Thunder preset into a sequencer

Operating the Blue Thunder

Note: When performing data dumps to and from the Blue Thunder, always perform the dump in real

time sequence mode. This will ensure that data loaded back into the Blue Thunder is not sent
faster than the Blue Thunder can receive it.

Also, make sure that the sequencer's MIDI filter is set to accept SYSX information.

Connect a standard MIDI cable from the MIDI OUT of the transmitting Blue Thunder to the
MIDI IN on the receiving sequencer.

Step 1

Step 3

Turn the FUNCTION SELECT controls on the transmitting Blue Thunder until "MIDI
DUMP/LOAD" is displayed.

Step 4

Turn the PARAMETER SELECT control on the transmitting Blue Thunder until "BULK
DUMP/LOAD" is displayed.

MIDI DUMP/LOAD

BULK DUMP/LOAD

TRANSMITTING BLUE THUNDER

Step 5

Start the sequencer recording.

RECORD

Press the EDIT button to enter the “EDIT MODE”

EDIT MODE

Step 2