Fcc statement – Delphi XpressRC SA10316 User Manual
Page 72
Please note that the power cable that has been supplied with your device is supplied with permanently
attached ferrite beads . It is the responsibility of the user to use the power cable with the ferrite bead
The user is cautioned that changes or modifications not expressly approved by XM
Satellite Radio Inc . can void the user’s authority to operate this device .
This device complies with Part 15 of the FCC Rules . Operation is subject to the following two conditions:
•
This device may not cause harmful interference .
•
This device must accept any interference received, including
interference that may cause undesired operation .
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules . These limits are designed to provide reasonable protection against harmful
interference in a residential installation .
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the installation instructions, may cause harmful interference to radio communica-
tions . However, there is no guarantee that interference will not occur in a particular installation . If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna of the affected receiver .
•
Increase the separation between the XM equipment and the affected receiver .
•
Connect the XM equipment into an outlet on a circuit different from that to which
the affected receiver is connected .
•
Consult the dealer or an experienced radio/TV technician for help .
WARNING! The FCC and FAA have not certified this Satellite Radio Receiver for use in
any aircraft (neither portable nor permanent installation) . Therefore, XM Satellite Radio cannot support
this type of application or installation
FCC Statement