Delphi XpressRC SA10316 User Manual
Page 17
1
Installing the swivel mount
CAUTION! The adhesive used with the swivel mount may make it difficult
to remove . Do not install this mount on leather surfaces and make sure
the air temperature is at least 60°F (15°C) .
1
Locate a flat surface for the mount . Make sure there is ample room
for the XM cradle and radio when installed .
Clean the surface with the preparation kit and let it dry thoroughly .
Peel off the adhesive liner . Position, press, and hold the swivel mount
in place for 30 seconds .
IMPORTANT! Let the adhesive cure for 24 hours before attaching the XM
cradle and radio to the mount .
Turn the swivel to accommodate the XM cradle and radio . Adjust the
tension via the center screw .
You can adjust this screw
to adjust the tension of the
mount with a screwdriver .