Notice – Remy 50MT Conventional Solenoid and Plunger User Manual
Page 2
NOTICE
- Only licensed Remy International Inc. product and component parts should be used, and the use of other parts or modifications not
approved by Remy International Inc. will void all applicable warranties. The failure to carefully follow these Installation Instructions, set forth above, will void
all applicable warranties. Delco Remy
®
is a registered trademark of General Motors Corporation, licensed to Remy International Inc., Pendleton, IN 46064.
© 2012 Remy international Inc. All rights reserved.
2
9. Install ground terminal nut and washer assembly on solenoid and tighten to 1.8-4.3 Nm (16-38 lb in).
10. Reinstall starter and connect cables and other leads, as removed.
11. Reconnect the negative (-) cable at the battery.
Technical support: USA 800 854 0076, Mexico 01 800 000 7378, Brazil 0800 703 3526, South America 55 11 2106 6510 or visit
delcoremy.com
- 28MT (2 pages)
- 29MT STARTERS HARDWARE PACKAGES (4 pages)
- 29MT HD (4 pages)
- 37MT Side Ground Terminal (2 pages)
- 37MT Armature (4 pages)
- 37MT Brush (4 pages)
- 37MT CE Housing (4 pages)
- 37MT Conventional Solenoid (4 pages)
- 37MT DE Housing (2 pages)
- 37MT Field Coil (4 pages)
- 37MT Lever Housing (5 pages)
- 37MT Drive (4 pages)
- 37MT SSL Solenoids (4 pages)
- 37MT Terminal Lead (2 pages)
- 37MT Universal (2 pages)
- 38MT Brushes (2 pages)
- 42MT Upgrade from Standard to OCP (4 pages)
- 50MT Armature (2 pages)
- 50MT Brush Plate Brush (2 pages)
- 50MT CE Housing (3 pages)
- 50MT DE Housing (2 pages)
- 50MT Drive (4 pages)
- 50MT Lever Housing (4 pages)
- 50MT Motor 12V 24V Semi Solid Link Solenoid (2 pages)
- 50MT Pole Shoe and Field Coil (4 pages)
- 50MT Pinion (4 pages)
- Dash Mount Magnetic Switch (Relay) 10511610 (2 pages)
- 28MT GEAR REDUCTION HEAVY DUTY STARTING MOTORS (2 pages)
- 37MT DELCO REMY HEAVY DUTY STARTING MOTORS (2 pages)
- 38MT GEAR REDUCTION HEAVY DUTY STARTING MOTORS (2 pages)
- 44MT™ GEAR REDUCTION HEAVY DUTY STARTING MOTORS (2 pages)
- 21SI All Replaceable Components 10539632 (3 pages)
- 21SI "I Terminal Retrofit Kit 10511625" (2 pages)
- 24SI™ HD (7 pages)
- 24SI™ ALTERNATORSSLIP RING END ROTOR BEARING (2 pages)
- REPLACING 25SI REGULATOR (2 pages)
- 33SI™ HD ALTERNATOR REPLACEMENT (3 pages)
- 40SI™ HD ALTERNATOR REPLACEMENT (5 pages)
- 50DN OIL-COOLED GENERAT0RS (2 pages)
- 50DN ALTERNATOR DRIVE END FRAME AND SEAL UPGRADE PACKAGE KIT (2 pages)
- REPLACING 50DN ALTERNATOR SHAFT SEAL AND O-RING (2 pages)
- REASSEMBLING OF CS-144 GENERATOR (2 pages)
- REPLACING DELCO REMY 10SI ALTERNATORS (3 pages)
- 24SI™ ALTERNATOR (2 pages)