RAVE Sports Splash Trax Arch Bridge - Manual (Page 20)

the water. Float in shallow water until all pieces are connected together then
move to the desired location for anchoring.
Connecting Splash Trax Modules Together
Step 1
Bring two Splash Trax modules together so the oval rings on
the side and the Velcro flaps are facing each other.
Step 2
Two Kwik Lok straps are used to connect two Splash Trax
modules together
1. Attach the snap hook of one Kwik Lok strap to the outer most ring on
the bottom of one Splash Trax module.
2. Feed free end of the strap up through the oval ring on the side of the
same module.
3. Then down through the side ring of the other module.
4. Then through the bottom ring and back through the metal buckle.
5. Leave loose for now. Repeat for the second strap.
6. Tighten both straps until the modules are tight
against each other.
7. Important: Ensure there is no slack anywhere in
the strapping. Hand adjust if necessary to
ensure it is tight and secure between all
connection rings.
ALL 3 SIDES OF STRAPS MUST BE TAUGHT
20