RAVE Sports Turbo Sled - Manual (Page 9)

8
Align valve with hole in the cover of the side rail.
Inflate bladder 50% full and check to ensure
bladder is not twisted and valve is properly
aligned with the hole in the cover. Adjust the
bladder if necessary.
Inflate side rails to firm but not hard. Inflating the product too firm
initially can make it difficult to join the sections together. Assemble
slide with sections partially full and top off inflation pressure in side
rail tubes once entire slide is set up.
A special inflation adaptor (included with the
High Speed Inflator) is needed for the Inflatable
Start Mat. Simply lock the adaptor onto the end
of the inflation hose and insert into the valve
body. Turn ¼ turn to lock in place.
NOTE: This inflation adaptor will automatically open the valve
when inserted and will close the valve when removed. You do
not need to manually open/close the valve when using this
special adaptor.
Inflate mat section so when kneeling on it with
one knee, it does not allow contact with the
ground. CAUTION: Do not fill until hard or the
mat will not provide proper cushioning.
To manually open valve,
depress the stem and rotate clockwise. To
close valve, depress the stem and rotate
counter-clockwise.
Note: It is normal for the air pressure within
the tube to fluctuate depending on air and water temperatures. It
may be necessary to increase or decrease the air pressure in your
product accordingly. To avoid damage on extremely hot days it may