RAVE Sports Turbo Sled - Manual (Page 8)

7
Assembling your Turbo Chute
Step 1: Setup
Make sure the slope and surrounding area are free from
obstructions. If using into a lake, ensure lakeshore and planned
entry area into the water are free from obstructions as well.
Ensure that the entire length of the chosen slide path is free of
rocks, bumps, depressions, sticks, etc., and the surface beneath the
Turbo Chute is either smooth grass or sand.
A minimum of 7
° slope angle is suggested for sliding (approx. 5 ft
drop in 40 ft of length). DO NOT exceed 40 ° slope angle.
C A U T I O N
THE STEEPER THE SLOPE,
THE FASTER AND FURTHER YOU WILL SLIDE
DO NOT use on slopes that create danger to the user as a
result of excess speed.
Do not use if your hill or lakeshore does not meet these
requirements.
Place deflated slide sections on the shore or similar firm surface
with sufficient clearance to inflate and transport the inflated
section to the location you intend to use it. Make sure the area is
free of all sharp sticks, rocks or other objects that could puncture
the product.
Step 2: Inflate
To inflate, use either the RAVE High Speed Inflator (#01083) or the
RAVE 120v Canister Inflator (#02342). Locate the valves on each side
rail of the slide straight sections and Splash Pool (if using on Lawn).
!!