RAVE Sports Turbo Sled - Manual (Page 12)

11
Step 3: Lawn Assembly & Positioning
Begin by positioning the Splash Pool at the bottom of the hill where
there is level ground. This will be the end of your slide. Attach each
straight Turbo Chute section so that
the warning label is positioned on
the lead (uphill) end of the slide.
Ensure all Velcro ® strips are
securely fastened together and
there is a smooth transition from
section to section without gaps.
As you attach each section of your
Turbo Chute, ensure that it is
properly staked down using the provided stakes and straps that are
attached to each section. Straps should be staked 45 degrees uphill
to prevent downhill movement of the Turbo Chute during use. The
Inflatable Start Mat should be at the top of the hill and should be the
last section to be attached to the slide and
staked down.
Before sliding, fill Splash Pool to the top
with water and check to make sure all
stakes are secure.
To correctly position your slide:
1. Inflatable Splash Pool should be placed on level ground and
never on a downslope. Water in pool should be a minimum of 4
inches deep.
2. The Inflatable Start Mat should be situated at the beginning of
the slide on a level or slightly downward sloping surface of no
more than 10 degrees in slope.
3.
Add additional Turbo Chute sections if slide is too short to meet
the criteria above.