RAVE Sports Rope Swing Freestanding Package - Manual (Page 11)

10
Step 6: Install frame onto base tube.
Using 3-4 people, tip up the frame and carry it to the inflated base
tube utilizing one person on each leg of the swing frame.
First, insert the frame onto the frame posts nearest to
the swing platform. Make sure the frame pipes are
fully inserted down onto the posts.
Next, insert the remaining two ends of the frame onto
the frame posts at the far ends of the base tube.
NOTE: If the frame is too difficult to push onto the outer posts,
release some air in the base tube. This will allow the posts to move
freely and align with the frame pipes.
Once the frame is installed onto the posts, insert all remaining bolts
and tighten securely. Re-inflate the base tube, if necessary, until firm.
Slide black foam sleeves down to completely cover the lower bolts
and all exposed steel on the lower section of the frame.
Step 7: Connect Rope Swing to Aqua Jump or Bongo
Float the assembled Rope Swing out to the Aqua Jump water
trampoline or Bongo.
Choose a side to mount the Rope Swing that provides adequate
clearance to swing into the water that is 10 feet or deeper.
There are three straps coming off the underside of the Rope Swing
platform. Feed the ends of these three straps
underneath the spring cover pad on the water
trampoline and to the inside of the Aqua Jump tube.
On the Bongo, feed the straps through the openings
in the jump surface lacing.
Take the single strap that is on the frame side of the
Rope Swing tube, run it underneath the Aqua Jump tube and loosely
connect it to the center buckle strap coming from the platform.