Raloy IP Functions for KVM - Manual (Page 26)

23
Primary DNS Server IP Address
IP address of the primary Domain Name Server in dot notation. This option may be
left empty, however the IP module will not be able to perform name resolution.
Secondary DNS Server IP Address
IP address of the secondary Domain Name Server in dot notation. It will be used in
case the Primary DNS Server cannot be contacted.
Remote Console And HTTPS port
Port number at which the IP module’s Remote Console server and HTTPS server
are listening. If left empty the default value will be used.
HTTP Port
Port number at which the IP module’s HTTP server is listening. If left empty the
default value will be used.
Telnet Port
Port number at which the IP module’s Telnet server is listening. If left empty the
default value will be used.
Bandwidth Limitation
The maximum network traffic generated through the IP module ethernet device.
Value in Kbit/s.
Enable Telnet Access
Set this option to allow accessing the IP module using the Telnet
Gateway see the section 6.1.2.
Disable Setup Protocol
Enable this option to exclude the IP module from the setup protocol. Setup protocol
is a proprietary layer-2 MAC-based protocol to allow some configuration software
to detect IP MODULE devices in the network, even without IP address, and then
config network related settings to IP module.
LAN Interface Settings
The “Autodetect” will set the ethernet speed to the fastest possible value supported
by both endpoints of the link. For example, if you use a 10M/half duplex HUB, this
speed will be auto-selected. If this option does not work with some network device
(HUB, switches, and routers), you can set the Ethernet interface speed of IP
module manually to the values as supported by the network device.
3-4.2 Dynamic DNS