Pitney Bowes DM800i Series - Manual (Page 15)

DM800i™ Series Digital Mailing System Operating Guide
SV61162 Rev. D 1- 5
• Do not use the telephone or equipment connected to the telephone line
in the vicinity of a gas leak.
• Do not connect your postage meter (Postal Security Device) to a digital
phone line. The device’s built-in modem is designed to work with an
analog phone line only. (Your fax machine is usually connected to an
analog phone line.) If you do not know if your line is digital, call your
phone provider for verification.
• Disconnect the telephone cord from the wall before removing the 
IntelliLink® Control Center.
DJPS/DMPS
Power Stacker
• Use only Pitney Bowes approved supplies, in particular aerosol dust-
ers. Improper storage and use of aerosol dusters or flammable aerosol
dusters, can cause an explosive-like condition that could result in a per-
sonal injury and/or property damage. Never use aerosol dusters
labeled flammable and always read instructions and safety precautions
on the duster container label.
• To obtain Pitney Bowes supplies, please contact our Pitney Bowes
Supply Line™. Material Safety Data Sheets can be obtained on the web
or from our Pitney Bowes Supply Line™. Refer to the Pitney Bowes
Contact Information List
at the front of this guide for phone numbers
and web site information.
• Use the power cord supplied with the machine and plug it into a prop-
erly grounded wall outlet located near the machine and easily accessi-
ble. Failure to properly ground the machine can result in severe
personal injury and/or fire.
• Avoid touching moving parts or materials while the machine is in use.
Keep hands, loose clothing, jewelry and long hair away from all moving
parts.
• Do not remove covers. Covers enclose hazardous parts that should
only be accessed by properly trained service personnel. Immediately
report to Pitney Bowes Service any damaged or non-functioning com-
ponents that renders the unit unsafe.
• Place the unit in an accessible location to allow for proper venting of the
equipment and to facilitate servicing.
• The power cord wall plug is the primary means of disconnecting the
machine from the AC supply.
• Do not use an adapter plug on the line cord or wall outlet.
• Do not remove the ground pin from the line cord.
CAUTION:
To reduce the risk of fire, use only the 26
AWG telecommunication line cord either supplied with
the machine or supplied separately.
WARNING!
Follow normal safety precautions for all
office equipment whenever using the DJPS/DMPS
Power Stacker.