Pitney Bowes Mailstation2 (K7M0) User Manual
Page 10
6
Special Network Settings
This section is needed only if your network requires special settings
to operate properly, such as static IPs and proxy server IDs, the
settings will need to be added to the Communication Device.
Consult your IT specialist to determine if this is necessary.
Follow instructions exactly in the sequence shown below.
To enter special settings
a. Disconnect power ( ) from the meter.
b. Be sure the Communication Device is:
- connected to an active Internet port
- plugged into a power outlet
- the right LEDs are blinking in an orange and/or green pattern.
c. Download the setup software to your computer by going to:
www.pb.com/support/netsetup
Click the button for your type of computer.
Note: If a firewall message appears, click the button that allows
the download to proceed.
d. Save the software “pbSmartLAN” to your computer, then
open and run it.
e. Click the Setup for Network Cable Connection button.
Follow the setup wizard and enter the appropriate special settings.
Communication
Device