Peg-Perego Primo Viaggio Convertible User Manual

Page 44

- 44 -

Installing your child restraint in the vehicle - Forward Facing mode

Important! Remove newborn filler cushion in

forward facing mode (see page 55).

FORWARD FACING MODE USING

LAP BELT (TYPE I)

1. Before installing the child restraint in the

vehicle, make sure that the backrest is in the

upright position or adjust it using the handle

located below the front edge of the shell (A)

as shown in detail.

2. Lean the upright child restraint, unoccupied,

on the selected vehicle seat. Make sure that

the LATCH straps are stored in their proper

location (page 39 - picture2) and that the rear

openings in the structure are free and ready

for use. Open the lock-off clips, as shown in

the picture .

3. Pull the vehicle belt at full available length

and thread the belt through the openings

in the structure behind the child restraint as

shown in the picture.

4. Buckle the vehicle belt and check that the

vehicle belt is free of any entanglement.