Peg-Perego Primo Viaggio Convertible User Manual

Page 29

- 29 -

Installing your child restraint in the vehicle - Rear Facing mode

5. Attach the lower connectors to the lower

anchors of your vehicle located at the joint

line between seat and backrest. Check your

vehicle owner’s manual to learn what is the

best place for your child restraint. When the

LATCH straps are connected to the lower

anchors, an audible click will be heard. If

this is not the case, repeat the operation

and double check that the latch is attached

and working by trying to pull the lower

connector away from the lower anchor.

6. Push down the child restraint (A) into

the seat with your own body weight and

at the same time pull the strap ends in

order to tighten the latch straps (B). Check

that the connectors are evenly tightened

and that the seat is not leaning sideways.

7. Picture shows the correct strap path

when the seat is attached using the

LATCH connectors. Make sure the seat is

properly leveled as explained on page 27.

Verify that the child restraint is secure.

A secure child restraint will not move

more than 1 inch near the latch anchors.