Peg-Perego Primo Viaggio Convertible - Manual (Page 43)

- 43 -
Installing your child restraint in the vehicle - Forward Facing mode
5. Push the child restraint firmly into
the vehicle seat and pull the vehicle belt
eliminating any slack. While pushing the
seat down (A), pull the lap portion of the belt
from the fixed point toward the buckle (B).
Then pull the diagonal portion of the belt (C).
6. Close the lockoff clip following the
procedure shown in picture (D and E).
Make sure that only the lap portion of the
belt passes through the opened lockoff
clip on the side where the shoulder
strap goes up to the retractor (picture 6).
7. Open the lockoff clip on the buckle side.
Make sure that both the lap and shoulder
belts go through the lockoff near the buckle.
Close the lockoff clip following the procedure
shown in picture 6 (D and E).
Verify that the child restraint is secure. A
secure child restraint will not move more
than 1 inch near the seat belt anchor.
Important Note: The lock off clips located
on the side of the Convertible seat are used to
enhance the stability during normal use. The lock
offs are not designed to replace an automatic
locking retractor or a locking latch plate.
5
6
7
A
B
C
D
E