Peg-Perego Primo Viaggio Convertible - Manual (Page 17)

- 17 -
Installing your child restraint in the vehicle
2.1 Lap/shoulder belt (3-point) with
Switchable Locking Retractor (ELR — >
ALR) and free sliding latch plate. This
type of seat belt has a latch plate that moves
freely along the belt. To activate ALR for child
restraint installation, some vehicle models may
require to pull the belt all the way out; some
other vehicle models may require to pull the
belt for a certain length (check vehicle owner’s
manual for details).
For installation of Primo Viaggio Convertible in
rear facing mode, leave the seatbelt in ELR mode
and use a locking clip avalaible with your child
seat (in rear compartment). Use of a locking
clip is explained at page 33. For installation of
Primo Viaggio Convertible in forward facing
mode, activate ALR mode, then tighten the belt
around the seat feeding the belt back into the
retractor. The belt will not extend unless you
unbuckle the belt and repeat the operation
from the beginning. With this installation, use
of a locking clip is not required.
Important Note: The lock off clips located
on the side of the Convertible seat are used to
enhance the stability during normal use. The lock
offs are not designed to replace an automatic
locking retractor or a locking latch plate. The
vehicle belt must be properly tightened to secure
the Convertible seat to the vehicle.
ELR ALR
1
FF
RF
√