DirecTV SAT GO - Manual (Page 16)

15
Before Using Your DIRECTV ® Sat-Go
Inserting Battery into the TV
You must insert or replace the batteries in the DIRECTV Sat-Go system when you:
+ Purchase the DIRECTV Sat-Go system.
+ Find that the DIRECTV Sat-Go TV is no longer operating correctly.
TIP: The Low Portable Battery symbol displays onscreen when the portable battery is
low. The power light will also blink every second for 10 minutes before switching the
DIRECTV Sat-Go to standby mode automatically. (Battery usage time is about 1 hour;
battery charging time is about 8 hours.)
SCREWS
1
2 3
1. Open the DIRECTV Sat-Go case and remove the TV by lifting the TV from the DIRECTV
Sat-Go case.
2. On the back of the TV, unscrew the two screws holding the battery cover in place.
3. Remove the cover from the battery compartment by sliding it outward.
4. Insert lithium battery pack (supplied).
5. Slide the cover over the battery compartment to replace the battery cover.
6. Replace the two screws to hold the battery cover in place and complete the installation.
A full charge can take as much as 8 hours. It is recommended that you charge the batteries
overnight before the fi rst use.
CAUTIONS:
- Remove batteries when you don’t use the DIRECTV Sat-Go system for long
periods. Liquid leakage from old batteries may cause operation failure.
- Don’t place the TV near a heater or damp place. Strong impact on the TV may
cause operation failure.
SatGo_03-30-07(converted).indd 15 SatGo_03-30-07(converted).indd 15 5/18/07 4:48:22 PM 5/18/07 4:48:22 PM