ParkZone PKZU2180 - Manual (Page 6)

6
EN
Your ParkZone® 4-channel DSM2/
DSMX RTF transmitter comes pre-
bound to the aircraft.
Remove the cover, install four of the
included batteries (noting proper
polarity) and reinstall the cover.
Installing Transmitter Batteries
3
4
1
2
6
5
Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally
Unique Identifi er) code of a single specifi c transmitter. You need to ‘bind’ your chosen Spektrum
™ DSM®
technology equipped aircraft transmitter to the receiver for proper operation.
For a list of compatible DSM2®/DSMX® transmitters, please visit www.bindnfl y.com.
NOTICE: When using a Futaba® transmitter with a Spektrum DSM module, reversing the throttle channel
is required.
Transmitter and Receiver Binding
 Binding Procedure Reference Table
1. Refer to your transmitter’s unique instructions for binding to a receiver.
2. Make sure the fl ight battery is disconnected from the aircraft.
3. Power off the transmitter.
4. Connect the fl ight battery to the aircraft. The receiver LED will begin to fl ash
(typically after 5 seconds).
5. Put your transmitter into bind mode. If you are using the transmitter that is
supplied with the RTF version, push the left control stick vertically into the
case (until it clicks) while powering on the transmitter.
6. Make sure the transmitter controls are at neutral and the throttle is in the low
position.
7. After 5 to 10 seconds, the receiver status LED will become solid,
indicating that the receiver is bound to the transmitter. If the LED does not
turn solid, refer to Troubleshooting Guide at back of manual.
5
6
For subsequent fl ights, power on the transmitter for 5 seconds before connecting the
fl ight battery.