ParkZone PKZU2180 - Manual (Page 11)

11
EN
The CG location is 20mm back from the leading
edge of the wing at the fuselage.
This CG location has been determined with the
included 1S 150mAh 3.7V Li-Po battery installed in
the battery cavity.
Balance the model on the edge of a metal ruler
to fi nd the Center of Gravity. Place the ruler at the
bottom side of the fuselage.
Adjusting Center of Gravity (CG)
20mm
Control Rates
We recommend using a DSM2/DSMX aircraft
transmitter capable of dual rates. Adjust according
to individual preferences after initial fl ight.
It is normal for linear servos to make noise. Noise is
not an indication of a faulty servo.
To achieve the proper Low Rate settings when
using a programmable DSM aircraft transmitter,
set the low rate value to 70% for aileron, elevator
and rudder.
High Rate Low Rate
Aileron 100% 70%
Elevator 100% 70%
Rudder 100% 70%