ParkZone PKZU2180 - Manual (Page 14)

14
EN
Post Flight Checklist
Additional Safety Precautions and Warnings
As the user of this product, you are solely
responsible for operating in a manner that does
not endanger yourself and others or result in
damage to the product or the property of others.
• Always keep a safe distance in all directions
around your model to avoid collisions or injury.
This model is controlled by a radio signal subject
to interference from many sources outside your
control. Interference can cause momentary loss
of control.
• Always operate your model in open spaces away
from full-size vehicles, traffi c and people.
• Always carefully follow the directions and
warnings for this and any optional support
equipment (chargers, rechargeable battery
packs, etc.).
• Always keep all chemicals, small parts and
anything electrical out of the reach of children.
• Always avoid water exposure to all equipment
not specifi cally designed and protected for
this purpose. Moisture causes damage to
electronics.
• Never place any portion of the model in your
mouth as it could cause serious injury or even
death.
• Never operate your model with low transmitter
batteries.
• Always keep aircraft in sight and under control.
• Always use fully charged batteries.
• Always keep transmitter powered on while
aircraft is powered.
• Always remove batteries before disassembly.
• Always keep moving parts clean.
• Always keep parts dry.
• Always let parts cool after use before touching.
• Always remove batteries after use.
• Always ensure failsafe is properly set before
fl ying.
• Never operate aircraft with damaged wiring.
• Never touch moving parts.

1. Disconnect fl ight battery from ESC
(Required for Safety and battery life).
2. Power off transmitter.
3. Remove fl ight battery from aircraft.
4. Recharge fl ight battery

5. Store fl ight battery apart from aircraft
and monitor the battery charge.
6. Make note of fl ight conditions and
fl ight plan results, planning for future
fl ights.
To remove the factory installed landing gear:
1. Lift the vertical strut of the landing gear wire until the horizontal strut is above the stop.
2. Gently pull the landing gear toward the center of the wing and away from the clips. Install in reverse
order, making sure the horizontal strut is inside the stop.
Removing and Installing Landing Gear
1 2