Installing clevises on control horns, Factory settings, Adjusting center of gravity (cg) – ParkZone PKZ5380 User Manual

Page 7: First flight preparation, Maintenance after flying

Tip: Turn the clevis clockwise or counterclockwise on the connector. Make
sure transmitter trims are centered before making this adjustment.

• Pull the elastic band from the clevis to the connector.
• Carefully spread the clevis and put the clevis pin in a selected hole in the

control horn.

• Move the elastic band to hold the clevis on the control horn.

Installing Clevises on Control Horns

Note: Not to scale

Factory Settings

Note: Not to scale.

Rudder

Tail

Wheel

Arms Horns

Aileron

Flap

Elevator

Arms

Horns

Install battery all the way forward in the fuselage using the hook and
loop strap. Turn the model until landing gear faces up to find balance
most easily.

Adjusting Center of Gravity (CG)

60mm (2.35 in) ± 2mm from

leading edge of the wing at

the fuselage

First Flight Preparation

• Remove and inspect contents
• Read this instruction manual thoroughly
• Bind aircraft to your transmitter
• Install the flight battery in the aircraft (once it has been fully charged)
• Make sure connectors move freely
• Perform the Control Direction Test with the transmitter
• Adjust flight controls and transmitter
• Adjust battery for center of gravity (CG)
• Perform a radio system Range Check
• Find a safe and open area
• Plan flight for flying field conditions

Maintenance After Flying

• Disconnect flight battery from ESC (Required for Safety)
• Turn off transmitter
• Remove flight battery from aircraft
• Recharge flight battery
• Repair or replace all damaged parts
• Store flight battery apart from aircraft and monitor the battery charge
• Make note of flight conditions and flight plan results,

planning for future flights

This manual is related to the following products:

PKZ5375