ParkZone PKZ5380 - Manual (Page 6)

6
en
Installing Wings
Installing Horizontal Tail
1. Install tube in hole in fuselage.
2. Install left horizontal tail on tube.
3. Install left horizontal tail in fuselage mount.
4. Install right horizontal tail on tube, in mount and on connector with left tail
panel.
5. Apply 4 pieces of tape on fuselage mounts and top and bottom
of horizontal tail.
6. Attach clevis to elevator control horn
(see manual instructions for clevis connection).
7. When needed, disassemble in reverse order.
1. Where installed, remove canopy hatch from fuselage.
2. Turn aircraft over so bottom of fuselage faces up.
3. Put wing’s guide pins in fuselage plate holes.
4. Where used, put aileron, flap and landing gear connectors in hole in fuselage.
Note: Make sure connectors do not fall out of fuselage after wing is installed.
5. Align and attach wing to fuselage using 3 screws.
CAuTIon: Do NOT crush or otherwise damage wiring when attaching
wing to fuselage.
6. Turn assembled fuselage and wing so the bottom of the wing is down.
7. Where used, connect aileron, flap and landing gear connectors to the receiver
or Y-harnesses.
Note: There is no difference between 2 connections on a Y-harness. Left and
right servo connectors do not have to be connected to a particular side of a
Y-harness.
8. Where needed, disassemble in reverse order.
M3 X 25
M3 X 25
Note: Not to scale. Not all wiring
is shown. Tape is not shown.