Installing the flight battery – ParkZone PKZ3680 User Manual

Page 5

• After you make the connection successfully, the LED light on the

charger will turn solid red, indicating that charging has begun.

• It will take approximately 30–40 minutes to charge a fully discharged

(not over-discharged) battery. As the battery nears full charge, the LED

light will begin to blink. When the battery is fully charged the LED light

will blink approximately every 20 seconds or will go out entirely.

Note: The Li-Po battery included with your P-51D Mustang will arrive

partially charged. For this reason the initial charge may only take

15–20 minutes.

Note: You can expect to charge the Li-Po flight battery approximately

15–20 times before it will be necessary to replace the AA

batteries in the charger. Replacing the included batteries with

alkaline batteries will result in more charge cycles than with the

included batteries.

Note: If LED remains on for longer than 40 minutes while charging and/or

5 seconds after removing the Li-Po flight battery, please replace the

AA batteries in the charger.

Installing the Flight Battery

Once the Li-Po battery has been fully charged, it’s ready to be installed in the

airplane.

Install the battery in the airplane by placing it into the slot on the bottom of

the fuselage with the plug facing toward the front of the airplane.

Note: If you are using E-flite mCX batteries or other batteries without

hook and loop tape, we have included extra hook and loop tape

pieces to allow you to use these batteries.