Palram SUNTO - Manual (Page 3)

SUNTOP ® 107 / 27 (American 4.2)
Installation Guide
13.02.2006 3
Screws and Washers
Crest fixing - Self-drilling ¼”x 2 1 /
2
” screw.
Recommended washer/gasket: 25mm diameter- galvanized /
aluminum / stainless metal washer attached to EPDM rubber gasket
of 55 to 65 shore hardness.
Never use PVC washers or any unapproved material.
PALRAM washers are highly recommended.
It is recommended to use a compatible crest rider with EPDM attached gasket.
Pre-drill the screw holes in the SUNTOP sheets, 3-4 mm bigger diameter than the screw.
Fastening Tips
Use adjustable electric screwdriver.
The screw must be installed perpendicular
to the SUNTOP sheet.
Important - Do not over-tighten!
Cutting / Sawing tools
Table or Portable circular saw with small teeth.
When Sawing use high blade speed and slow feed rate.
Support the sheet in the vicinity of the cut and clean dust
and splinters away.
Handling and Storage (Packed sheets)
Store in a shaded place, protect from direct sunlight and rain.
Avoid covering the sheets with heat absorbing materials.
Avoid contact or environment of chemicals.
Protect the sheets from any damage.
Accessories
Use only PALRAM approved accessories
Compatible Silicone.
Butyl Rubber or Expanding Sealing tape.
Closure Fixtures.