Directed Electronics 6000 - Manual (Page 25)

21
© 1999 Directed Electronics, Inc.
■ Panic mode enabled/disabled with the ignition on: Some
states have laws against siren capability in a moving vehicle.
■ Forced passive arming on or off: If your system is programmed
for passive arming and the forced passive arming feature has
been programmed on, the system will passively arm after one
hour, even if a protected entry has been left open. This
feature is useful if a door has been left ajar when leaving the
vehicle. Forced passive arming ensures that the security sys-
tem will be armed in every situation.
NOTE: When the system passively arms after one hour, the entry point
that has been left open, and anything connected to the same zone, is
bypassed and cannot trigger the system. However, the remaining inputs
to the system are fully operational.
■ Automatic Engine Disable (AED) on or off: The purpose of
this feature is to protect the vehicle from being stolen at all
times, regardless of whether or not the alarm is armed. If AED
is programmed on, the starter of the vehicle will be disabled
30 seconds after the ignition is turned off. Once the key is
turned off, the LED will flash slowly (one-half its normal
armed rate) to indicate the AED arming cycle. Thirty seconds
later, the starter of the vehicle will be disabled. To start the
car, it will be necessary to arm the car with the remote and
then disarm it with the remote. It is also possible to disarm
the AED feature by turning the ignition key to the "run"
position and pressing the Valet ® switch the programmed
number of times. AED is disabled when the system is in Valet ®
Mode.
NOTE: This feature will only function if the Failsafe ® Starter Kill relay has
been installed.