Directed Electronics 6000 - Manual (Page 17)

13
© 1999 Directed Electronics, Inc.
The operations described in this section refer to transmitter
buttons. Remember, the buttons used in all the instructions in this
guide correspond to a Standard Configuration transmitter. This
may not be how your transmitter is set up.
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solidly if you are entering Valet Mode, and
it will go out if you are exiting Valet Mode.
Your system has DEI ® ’s Nuisance Prevention ® Circuitry (NPC ™ ). It
prevents annoying repetitive trigger sequences due to faulty door
pin switches or environmental conditions such as thunder, jack-
hammers, airport noise, etc. Here’s how it works:
The alarm triggers three times. Each time, the same sensor or
switch is triggering the alarm. The three triggers are within 60
minutes of each other. NPC ™ will interpret this pattern of triggers
as false alarms. After the third trigger, NPC ™ ignores, or bypasses,
that sensor or switch (along with any other sensors or switches
sharing the same zone) for 60 minutes.
Nuisance Prevention ® Circuitry
Remote Valet ®