Datamax I-4208 - Manual (Page 51)

I-Class 41
Printer Options (continued)
BARCODE COUNT
—
00 (00-99)
Used to set the specific number of barcodes
to be read on the label. 00 selects AUTO
Mode, allowing a variable number of
barcodes to be read per label format.
AUTO Mode should not be used with
imaged (bitmapped) barcodes or with
certain bar code addendums as shown in
Appendix B.
REDUNDANCY LEVEL Used to ensure the data integrity of the bar
code. The selected level determines the
number of consecutive, identical decodes
required before passing the bar code (i.e., if
set to three times, the barcode will not pass
until it has decoded the same values three
times in succession.)
; Note: Depending upon the print speed,
higher verification levels may cause erroneous
failures when scanning multiple bar codes or
bar codes that are small in height.
READ BARCODE (1X) One decode per barcode.
— READ BARCODE (2X) Two decodes per barcode.
READ BARCODE (3X) Three decodes per barcode.
READ BARCODE (4X) Four decodes per barcode.
READ BARCODE (5X) Five decodes per barcode.
READ BARCODE (6X) Six decodes per barcode.
BUZZER Audible signal indicating a ‘good’ bar code.
; Note: Disable this function for higher label
throughput speeds.
ENABLED Enables the buzzer.
— DISABLED Disables the buzzer.
SET DEFAULTS Reset the current settings of the Scanner to
the default settings.