Martin Archery Martin Compound Bow - Manual (Page 9)

PARTS OF THE NITROUS CAM SYSTEM
CHANGING THE DRAW LENGTH
Your Nitrous Cam may be an X Shoot-
Through system or a standard system, but
the draw is adjusted basically the same. The
threaded module has numbers and dashes on
it that indicate what setting you are on while
you are adjusting it. The dashes signal 1/2"
draw increments. When you are adjusting
the draw, make sure that both modules are in
the same setting. To rotate the modules, you
will need to remove the mod screw closest
to the Cable Boss and loosen the module
screw that is closest to the Bearing Boss.
If you are using a Mini Module for short
draws, there is only one screw. Slide the
module to the desired position and replace
and tighten the screws in the appropriate
positions. The modules provide a longer
draw as the module number gets higher.
X-Module
Module
Module
Screws
Speed
Bearing
Base
Cam
Mod settings
Bearing
Boss
Cable
Anchor
Cable
Boss
Shooting
String
Anchor
5
Note: For more options in draw length adjustment see the section called Using Ni-
trous Mini Modules on the next page.