Martin Archery Martin Compound Bow - Manual (Page 11)

CONVERTING TO THE X SHOOT-THROUGH SYSTEM
The Nitrous-X system eliminates the cable guard and the pressures it creates.
Converting your Nitrous System to the X Shoot-Through System is very easy. All you
need to do is order a conversion kit from your dealer and it will come with X-Modules,
cables, long mod screws, and long axles. Your dealer can easily add the second module
to the top and bottom and then slide in the long axles with the use of a bow press. Install
the 4 cables and presto! You have a Nitrous-X system.
TRU-ARC+ CAM
The Tru-ARC+ is a very unique
cam system. It is technically a hybrid
cam because it is a blend of a dual cam
system and a single cam system. It has
the straight and level nock travel of a
dual cam and the timing simplicity of
single cams. It is a simple system to set
up and it is very easy to shoot. See the
following guide for complete set up and
tuning of the Tru-ARC+ System.
Top Module
Mod Screw
Speed Ball
Bearing
Shooting
String
Mod
Screw
Bottom
Module
Control
String
Speed Ball
Bearing
7
PARTS OF THE TRU-ARC CAM+ SYSTEM
Standard Modules
Standard Modules use two mounting screws. The X module is
noted with an X on the tail, it can be installed per the instructions
below to make your bow a shoot-through system. The (T) on the tail
of the mod notes that it will fit on the top cam (Note: left handed
shooters are opposite.) The module that is labled with a (B) goes
on the Bottom.
Mounting
Screw Holes
Let-Off
Designation
Countersink
Notes an X
Module
M
IN
I M
OD
M
INI
M
O
D
Mini Modules
Mini Modules use one mounting screw. The Mini Module will
give you an additional 2 inch reduction of draw length on any
Nitrous Cam System. If you are in the last two settings on the
Standard Mod, the Mini Mod will give you more draw length
flexibility and better performance in the shorter draw lengths.
Mounting
Screw Hole
Notes an X
Module
Let-Off
Designation
Countersinks