Martin Archery Martin Compound Bow - Manual (Page 14)

STRING CONFIGURATION
The string harness on the new Dyna
Cam is installed according to the dia-
gram to the right. Your string harness
should be installed by your qualified
Martin dealer. Pay close attention to
how the Shooting String leaves the cam.
Although cam rotation is not critical, use
this diagram as a loose representation of
proper cam rotation.
Shooting
String
2nd half
Shooting
String
Split
String
Shooting
String
comes
straight off
of curve
10
ADJUSTING THE DRAW
Using draw length modules, the
draw length can be adjusted in 1"
increments. The modules can also be
used to adjust the let-off. A high let-
off module is marked as F. A 65% let
off module is marked with a F/. (The
/ indicates 65% let-off.) To change
the draw length, replace the module
on the cam by removing the screws
that hold it to the cam. NOTE: do not
draw your bow without the module
installed. It will damage your har-
ness. The Dyna module sizes range
from F-1 to F-7. As the module num-
bers get higher, the draw gets longer.
The draw length can also be adjusted
in 1/2" increments using the pegs on
the back of the cam. The #2 peg is
the prescribed draw length for each
module. The #1 peg is 1/2" longer and
the #3 peg is 1/2" shorter.
1
3
2