Lodar 4 Function FET Receiver with Keypad, master output and IP Series Transmitter - Manual (Page 2)

S-, S+ Connections
For Safety Solenoid etc.
Part No. 9820 or 9821
STOP and -, when
connected together
will cause the Receiver
to power down
RS232 connection
for programming and
special features
SMA connector for
External Aerial Antenna
Part No. 9861, 9862,
9863 or 9869
Supply 12/24 V DC
40 Volts ABSOLUTE MAX
Outputs sockets
+, -, F1& F2
F3, F4, and Master.
The Receiver is designed
to handle 15 Amps, current
draw in excess of this will
trigger a system shut down.
Any output can handle
this maximum current.
Standard (Internal) Antenna
connection
Connection Detail
Lk1, when bridged
causes the Master
Output to be
Parallel
LK2, when bridged
causes the Master
Output to be
Continuous
Jumper MUST be
fitted to only ONE link
POWER DOWN RECEIVER BEFORE MAKING CHANGES
LED marked “5V”
Indicates power
supply for control
circuits is OK
LED’s marked
“F1 - F2 - F3 - F4 and M”
When ON indicate an
output to that function
LED marked “FAULT”
Indicates an overload is
present; the System
cannot be RESET until
overload is removed.
This LED blinks for 20
seconds when the
Receiver is initially
powered. A replacement
Transmitter has to be
registered during this 20
second period.
LED marked “SET”
Indicates system
is active
VOLTAGE
Working Range
12 Volts to 36 Volts DC
Limits
8 Volts minimum to
40 Volts absolute max.
Component Detail
Your product is marked with this symbol. It means that used
electrical and electronic products should not be mixed with
general household waste. There is a separate collection
system for these products.
In the EEC - Please contact your National Distributor (see
www.lodar.com for this information) who will inform you about
the take-back of the product. You might be charged for the
costs arising from the take-back and recycling. Small products
might be taken back by your local collection facilities.
Outside the EEC - If you wish to discard this product
please contact your local authorities and ask for the correct
method of disposal
Lodar
60 Sandwell Street,
Walsall, WS1 3EB.
England
www.lodar.com
email: [email protected]
Tel: +44 (0)1922 613633
Fax: +44 (0)1922 626991
CONTACT INFORMATION
92204RX.01E