Lodar 40 Function IP Series Transmitter with SHIFT function - Manual

923 SHIFT Series Transmitter Instructions
923TX.01E
The SHIFT Series Transmitter can control 2 Receivers, each with a
maximum of 20 functions.
The Green SET Button is used to control the SHIFT function of the
Transmitter. Both Receivers can therefore be operated by one
Transmitter.
When the Transmitter is in “standby” mode, pressing the Green
SET button once will turn on both Receivers.
When the Transmitter is active, each press of the Green SET
button will toggle between the PRIMARY Receiver and the SHIFT
Receiver.
The PRIMARY Receiver is active when the keypad LED is lit. The
SHIFT Receiver is active when the case LED is lit.
The Red Stop button will turn off both receivers, then place the
Receivers and the Transmitter into standby.
Keypad
LED
Case LED
SET button
STOP
button
To register a Shift Transmitter to both its PRIMARY and its
SHIFT Receiver.
Switch OFF/DISCONNECT the power to Both Receivers.
Press and HOLD both the Green SET and F1 buttons, DO
NOT RELEASE EITHER BUTTON. Both Keypad and
Enclosure LED’s will light up, now wait until only the Keypad
LED is lit. SWITCH ON or CONNECT power to the primary
Receiver and continue to hold both buttons for a further 10
seconds; the Primary Receiver is now coded. Switch off or
disconnect the power to this Receiver.
Press and hold the Green SET button again immediately
followed F1, DO NOT RELEASE EITHER BUTTON.
Ensure that the Case LED is lit, SWITCH ON or CONNECT
power to the Shift Receiver and continue to hold both
buttons for a further 10 seconds; the Shift Receiver is now
coded. Switch On or Connect the power to the Primary
Receiver.
Test, to confirm that both Receivers are working in their
respective modes.
You have now coded the Transmitter to both
receivers.
PRESS & HOLD
both SET and F1
Keypad LED
PRESS & HOLD
both SET and F1
Case LED
If you have any problems please phone either your local Distributor or Lodar directly:-
In the UK +44 1922 613633 In the US 1-877-257-1581