Lodar 1 Function FET Receiver and Standard Transmitter - Manual

2
or Disconnect Battery
IDENTIFY POWER
CONNECTION POINT
AND ISOLATE SUPPLY
Fuse
Remove fuse
Vehicle batteries contain gasses
which are flammable and explosive.
Wear eye protection and do not lean
over battery while disconnecting. Do
not wear metal jewellery.
! WARNING
92101.02E
1. The Receiver is designed to carry a maximum of 15 Amps. That is, for example,15 Amps
through one output or 5 Amps each through 3 outputs.
2. Master Output. This can be configured to Continuous or Parallel operation, see overleaf for
details.
3. If Receiver outputs are connected in parallel with an external switching device (wired remote)
the Receiver will instantly switch off when the wired remote is operated
4. Lodar Receivers have an isolation switch for safety, to allow for registering a MUST
replacement Transmitter.
5. Safety Feature. Both the Transmitter and the Receiver will “time out” after 30 minutes of
inactivity. This can be altered, ask your dealer.
1
! BEFORE YOU START
Your product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collection system for
these products.
In the EEC - Please contact your National Distributor (see www.lodar.com for this information) who
will inform you about the take-back of the product. You might be charged for the costs arising from
the take-back and recycling. Small products might be taken back by your local collection facilities.
Outside the EEC - If you wish to discard this product please contact your local authorities and
ask for the correct method of disposal
Wiring Instructions for 92 Series & 93 Series One Function Systems
CONNECT WIRES
RED
BLACK
GREEN
YELLOW
WIRE COLOUR
12 to 36 Volts DC
Positive
Negative
Output F1
Momentary
Output F2
Latched
9201
9301
YES
YES
YES
YES
FUNCTION
RECEIVER WIRES for given
Transmitter Operation
4
Transmitter Function I.D.
5
or re-connect Battery
ACTIVATE SUPPLY
Fuse
Replace fuse
Press the Transmitter
button to activate RESET
the system, and carefully
test each function for
correct operation.
7 TEST
6
CONNECT
TRANSMITTER
BATTERY
Batteries generally
have to be disconnected
when shipping.
SET Button switches system ON
When pressed switches
F1 ON and latches F2 ON
When released switches
F1 OFF ONLY (F2 remains ON)
STOP Button switches system OFF
When pressed switches F2 OFF (de-latch F2)
3
Secure using 5mm (3/16") bolts (not supplied)
through the 4 mounting feet
TAKE TIME TO LOCATE THE BEST POSITION
If necessary, power the Receiver and move it around
the vehicle until the required performance is achieved.
Operate the Transmitter and observe the Receiver
internal LED’s.
Mount as HIGH as possible
AVOID surfaces with HEAVY VIBRATION
AVOID DIRECT SPRAY from wheels
In a HOT CLIMATE fit in a SHADED position
Cable gland should face DOWN or BACK
Receiver 9206RX and 9306RX shown,
Waterproof to IP67, complete with 3 metres (10 ft) cables
CAUTION
MOUNT RECEIVER
!
Shown with optional Keypad
92 00 RX
& 93 00 RX
have
4 core cable
STOP POSITIVE
NEGATIVE