Lingenfelter L250110309 Lingenfelter C6 ZR1 Corvette Supercharger Front Cover 2009-13 v2.2 - Manual (Page 4)

Page 3.
1. Open the hood of the vehicle. If you have
been driving the vehicle, allow the vehicle to
cool down for a few hours before beginning this
work.
Some of the pictures in these instructions show
the hood removed. This was done to make it
easier to take the pictures. Although you can
remove the hood in order to provide easier
access, it is not required that you do so.
2. Open the rear hatch and open the battery
compartment cover. Using a 10 mm socket
wrench, disconnect the negative (-) battery
cable from the terminal on the battery. Cover
the cable end with electrical tape so accidental
connection to the battery does not occur.
3. Remove the engine sight shield (engine
cover) by pulling up on the cover to remove it
from the three (3) mounting posts.
4. Disconnect the mass air flow (MAF)
sensor electrical connector located at the air
inlet duct.